Installing The Traction Control Linkage - Toro PowerMax 726 OE Operator's Manual

2
Installing the Traction Control
Linkage
Parts needed for this procedure:
2 Hairpin cotter
3 Flat washer
Procedure
1. Insert the lower end of the rod into the lower link arm
so that the bent end of the speed control rod faces
rearward (Figure 4).
2. Secure the lower end of the speed control rod with a
flat washer and a hairpin cotter (Figure 4).
3. Place a flat washer on the trunnion (Figure 5).
1. Speed selector lever
2. Trunnion
4. Shift the speed selector lever into Position R2.
5. Rotate the lower link arm fully upward
(counterclockwise) (Figure 6).
Figure 4
Figure 5
3. Inner washer
4. Outer washer
6. Push down on the speed control rod and insert the
trunnion into the hole in the speed selector lever
(Figure 5).
Note: If the trunnion does not fit into the hole
when you lift up on the speed control rod, rotate the
trunnion upward or downward on the speed control
rod until it fits.
7. Secure the trunnion and upper end of the speed control
rod with a washer and a hairpin cotter.
Note: For easier installation, look down through the
opening in the speed selector (Figure 7).
1. Speed selector
9
Figure 6
Figure 7