Pentair 920 Series Installation, Operating And Maintenance Instructions page 81

INDUSTRIAL HEAT TRACING SOLUTIONS
parameter
Current Turns Ratio
Autocycle
Autocycle Interval
Autocycle Units
Override Source
Load Shedding
Common setup sub-menu
parameter
Temperature Units
Version
Ext. Input
Ext. Output
Flash Alarm Output
Alarm Output
Language
Point B Used
Passcode
Scroll Delay
Copy Config...
Communication setup sub-menu
parameter
Protocol HTCBUS
HTCBUS Addr (factory ID)
Modbus Addr *n/a (1)
Modbus Sub Addr *n/a (0)
Baud Rate Auto
Parity *n/a (None)
Hardware None, modem, RS-232, RS-485 n/a
Driver Auto
Profile Auto
Tx Delay 0.06 secs
*n/a Parameter may only appear if certain features are enabled. Values shown in brackets are
Pentair Thermal Managament defaults if the settings are enabled.
This information defines the default 920 Series control module configuration as set by Pentair
Thermal Managament for firmware up to V3.2x. These settings are subject to change without
notice.
It is the user's responsibility to verify that all configuration parameters are chosen appropriately
for the intended application.
EN- Raychem920series-IM-H56874 05/15
factory user
1.00 to 1
Enable
8
Hours
Remote
Disable
factory user
°F
V3.2x.xx n/a
Not used
Not used
Yes
N.C.
English
Yes
0
0.15 secs
(see user manual)
factory user
81 / 82