Appendix H: Cabinet Separation - Mitsubishi Electric WS-55815 Owner's Manual

Appendix H: Cabinet Separation for Model WS-65815
For Mitsubishi Dealers and Service Personnel Only
The Mitsubishi TV model WS-65815 projection television cabinet has been assembled in two pieces. These
pieces may be separated to allow for easier delivery and setup. The instructions below show how to safely
separate and reattach the cabinet.
This projection television weighs over 249 pounds and has many sensitive components. This dismantling
procedure should be done by authorized Mitsubishi Dealers or Service Personnel ONLY.
Cabinet-Top
The following operations should be performed by two people:
3
Front Glossy Panel
2 Lower Bracket (Screw)
1
Speaker Grille
6
Plastic Cover (Screw)
5
Connector (LF-ZF)
4
Front Board (Screw)
7
2" Approximately.
Bracket
(Apply force here)
If needed.
1. Remove Speaker Grille by pulling forward from
left and right sides of TV.
2. Remove Front Glossy Panel screws
at lower brackets.
3. Slide Front Glossy Panel to right
side approximately 1/2", then pull
away from TV.
4. Remove the screws attaching Cabinet-Top and
Cabinet-Bottom from the front boards.
5. Disconnect the connector (LF-ZF).
6. Remove the decorative Plastic Cover on each
side of the cabinet. Remove the exposed Screw
on each side.
7. Secure the Cabinet-Bottom from moving, then slide
forward the Cabinet-Top (may require some added force).
Carefully lift the Cabinet-Top straight up until the interlock
Tabs are clear from Cabinet-Bottom.
8. Carefully place lower rear surface of Cabinet-Top on floor.
9. Once you have moved and positioned
the Cabinet-Bottom to its desired location,
reverse the procedure and mount the Cabinet-Top
on the Cabinet-Bottom . Be sure to align the
Brackets properly. K E E P F I N G E R S C L E A R O F A L L
J O I N T S ! Replace the Screws and decorative Plastic
Covers that were removed in step 6. Rejoin the
connectors per step 5. Replace the screws per step 4.
Reinstall the Glossy Panel and Screws per step 2.
Reinstall the Speaker Grille per step 1.
Cabinet-Top
Interlock Tabs
Cabinet-Bottom
8
Cabinet-Top
Lower Rear Surface
89