Headlight Lamp Replacement - Polaris RANGER 570 Owner's Manual

MAINTENANCE
Fuses
If the engine stops or will not start, or if you
experience other electrical failures, a fuse may need
replacement. Locate and correct any short circuits
that may have caused the blown fuse, then replace
the fuse.
The fuse box is located in the electrical
compartment under the left rearmost seat. Spare
fuses are provided in the fuse box.
If you suspect that a fuse or relay may not be
working properly, please see your POLARIS dealer.
Fuse Size
5A
10A
20A EFI, Power Steering (if equipped),
20A Circuit
Breaker
Lights
Poor lighting can result in reduced visibility when driving. Headlight and taillight lenses
become dirty during normal operation. Clean lights frequently and replace burned out lamps
promptly. Do not operate this vehicle at night or in low light conditions until the headlight is
replaced. Always make sure lights are adjusted properly for best visibility.
When servicing a halogen lamp, don't touch the lamp with bare fingers. Oil from your skin
leaves a residue, causing a hot spot that will shorten the life of the lamp.

Headlight Lamp Replacement

1. Access the headlamp wiring harnesses
through the front wheel wells.
CAUTION! Hot components can cause burns to skin.
Allow lamps to cool before servicing.
2. Unplug the headlamp from the wiring
harness. Be sure to pull on the connector, not
on the wiring.
3. Turn the lamp counter-clockwise to remove
it.
4. Install the new lamp.
Tip: Make sure the tab on the lamp locates properly in
the housing.
5. Reinstall the harness assembly into the
headlight assembly.
80
Feature Supported
Brake Light
Drive System, Fuel Pump
Lights, Accessories
Fan
Connector