Engaging Awd; Disengaging Awd - Polaris RANGER 570 Owner's Manual

OPERATION
All Wheel Drive/Rear Differential System (if equipped)
The 4X4 rear axle is equipped with a lockable differential that allows the operator to choose
between an open differential or a closed differential. For models that are not equipped with a
lockable rear differential, refer to the All Wheel Drive section beginning on page 46.

Engaging AWD

Press the top of the switch to engage All Wheel Drive
(AWD). The 4X4 indicator illuminates in the rider
AWD
information center to indicate that the vehicle is in AWD.
When the AWD switch is on, the front gearcase will
Differential Lock
automatically engage any time the rear wheels lose
traction. When the rear wheels regain traction, the front
gearcase will automatically disengage. There is no limit to
Differential Unlock
the length of time the vehicle may remain in AWD.
Initially, the vehicle's electronic system will not enable the
AWD until the engine RPM is below 3100. Once enabled, the AWD remains enabled until
the AWD switch is turned off. If the switch is turned off while the front gearcase is moving,
it will not disengage until the rear wheels regain traction.
Engage the AWD before getting into conditions where front wheel drive may be needed. If
the rear wheels are spinning, release the throttle before switching to AWD.
NOTICE: Switching to AWD while the rear wheels are spinning may cause severe drive shaft and
clutch damage. Always switch to AWD while the rear wheels have traction or are at rest.

Disengaging AWD

Move the AWD switch to the center or bottom position to disengage AWD. If the switch is
turned off while the front hubs are driving, they will not release until the rear wheels regain
traction.
In some situations, the front gearcase may remain locked after turning the AWD switch off.
If this occurs, you may notice increased steering effort and some vehicle speed restriction.
Perform the following procedure to unlock the front gearcase.
1. Stop the vehicle.
2. Operate in reverse for at least 10 feet (3 m).
3. Stop completely.
4. Shift into low gear and drive forward.
5. If the front gearcase remains locked after following these instructions, see your dealer
for service.
47