How To Charge; How To Start; During Charging - LiteHawk XXL II Instruction Manual

Quick Tip: always turn the transmitter on first and Quick Tip: always tu
off last. off last.
How to charge the Litehawk XXL II:
- Make sure that battery and connectors are dry.
You will notice that there are 2 plugs with wires coming out of the battery. The white
plug with the blue, black, and red wires is the balance plug. This is the plug you use with
the supplied balance charger. This is a keyed plug and will only go in one way. Unplug
the red battery connector from the helicopter if plugged in.
1. Plug your wall mount power supply into a 120V outlet and connect the balance
charger into the opposite end. The red light on the balance charger will be solid red to
indicate there is power.
2. Connect the battery's white 3 pin balance connec-
tor into the corresponding port on the balance
charger. A green light will come on, this indicates
that the battery is being charged. Charging time is
Approx 1 - 1.5 hours.
3. Charging is completed once green light goes out
and the red light stays solid on. If both lights are still
on for more than 2 hours, unplug the battery as the
charger may be defective. Discontinue use immedi-
ately and call LiteHawk Technical Support.
4. Once charging is complete, unplug battery from
charger and unplug charger from wall outlet.

During charging:

- It is normal for the battery to get warm during the charging process. Do not charge
the battery on a surface that is flammable or can be damaged by heat.
- Do not leave the battery and charger unattended while charging.
- After charging, unplug charger from wall outlet.
- Do not store the battery plugged into the charger.
- It is best to charge your battery fully before using it for the first time.
- DO NOT leave the battery charging unattended under ANY circumstances!

How to Start!

1/ Turn ON the controller - you will see a flashing red LED light indicating the power is
on. Make sure helicopter battery is NOT plugged in.
2/ Place the helicopter on a flat surface and plug the red battery connector into the
helicopter.
3/ Move the throttle (left) stick on remote control fully up, then fully down - The LED
light on the controller will now be solid. This means that the model and the controller
are bound.
- Your helicopter is now ready for its flight.
www.litehawk.ca
R