Download Print this page

Troubleshooting - Velleman CAMSETW16 User Manual

Outdoor colour camera kit with 2 cameras

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Keys
Function
Select channel keys (19)
Press '+' to show next channel, '-' to show previous channel (21)
Initialize loop:
1. In normal mode, press and hold the loop key (20) for 3 seconds. ' ' flashes
2. Press the channel selectors to indicate which channels need to be looped
3. Press the loop key (20) again to save the set-up. Scanning begins
Press the loop key (20) to start scanning all channels
Lock/Unlock the remote control to avoid accidental touches or interference from
other IR controllers. To lock, press the lock key (18) once (' ' is displayed for
±1s), to unlock, press the lock key again (' ' is displayed for ±1s).
When the remote control is locked, the cannel button (17) on the receiver still
works.
Battery
10.
The remote control is battery operated. Before first use, remove the battery protection
tape.
To replace the battery, face the back of the remote control, push the small tab (1) to the
right and pull down (2, see image below). The battery cover slides out of the remote
control.
Replace the old battery with a new lithium battery type CR2025. Make sure to use the
correct polarity.
Removing the battery when the device is not in use will extend the lifetime.
Do not attempt to recharge batteries and do not throw them in fire as they may explode.
WARNING: handle Lithium batteries with care, observe warnings on
battery casing. Dispose of batteries in accordance with local regulations.
Keep the battery away from children.

Troubleshooting

11.
Image
Sound
No
No
Snow
Noisy
Ghost image
Normal
No colour
Normal
Normal
Noisy
00 (12/08/2008)
CAMSETW16
Check power supply on camera and receiver.
Check whether camera and receiver are on the same channel.
Check whether the distance between camera and receiver is within
limits.
Possible interference with other devices.
Check whether the distance between camera and receiver is within
limits.
TV system mismatch (PAL/NTSC), or night vision enabled
Possible interference with other devices.
Possible reason/solution
6

Advertisement

loading