Sleep Timer; Battery Installation - Mitsubishi Electric LT-37131 Owner's Manual

Remote Control, continued
1
2
3
4
7
8
9
10
16
17
23 24 25
26 27 28
22
Figure 1. Remote Control Overview

Battery Installation

1. Remove the remote control's back cover by gently
pressing in the tab and lifting off the cover (Figure 2).
2. Load the batteries, making sure the (+) and (-) polarities
are correct. For best results, insert the negative (-) end
first.
3. Snap the cover back in place.
Low Battery Indicator
If the POWER button blinks five times after you have pressed
any button, the remote control batteries are low and should
be replaced.
1
5
2
Figure 2. The remote control requires two AA alkaline
batteries.
6
11

Sleep Timer

12
Setting the Sleep Timer
1. Press SLEEP on the remote control.
2. Press SLEEP additional times to increase the time in 30-
13
minute increments up to the maximum of 120 minutes.
3. Press EXIT or wait five seconds without pressing any
14
buttons for the message to disappear.
15
4. Press SLEEP to view the time remaining before the sleep
timer turns off the TV.
18
Cancelling the Sleep Timer
19
1. Press SLEEP to display the on-screen message.
2. Press SLEEP repeatedly until OFF is displayed.
20
Note: After five seconds of inactivity, the message
21
box will disappear.
Care
For Best Results from the Remote Control:
• Use only alkaline batteries.
• Be within 20 feet of the equipment.
• Do not press two or more buttons at the same time
unless instructed to do so.
• Do not allow unit to get wet or become heated.
• Avoid dropping on hard surfaces.
• Do not use harsh chemicals to clean. Use only a soft,
lightly moistened cloth.
• Do not mix old and new batteries.
• Do not heat, take apart, or throw batteries into fire.
Resetting the Remote Control
If the slide switch is set to TV and the TV does not respond
properly, do the following to reset the remote control.
1. Press and hold POWER for several seconds until the
button blinks twice and goes off.
2. Release the POWER button.
3. Press keys 0 0 9 3 5 . The POWER button will blink twice
when you finish entering the code.
Chapter 3. TV Operation
37