Mitsubishi Electric LT-37131 Owner's Manual page 19

Back and Side Panels, continued
8
9
Back Panel 2
4. AVR OUT
(Audio only)
AVR OUT (AUDIO/ViDEO RECEIVER OUT) L/R jacks
send analog audio of the program currently shown on
the screen to an A/V surround sound receiver or stereo
system. Digital audio from digital channels, FireWire®
(DTVLink/IEEE 1394) devices and HDMI devices is con-
verted to analog audio by the TV. If using an analog A/V
receiver or stereo system, this is the only audio connec-
tion needed between it and the TV.
5. MONITOR OUTPUT
Use these composite video and left/right audio jacks
to send analog video and audio signals to an external
recording device such as a VCR. The signals from these
jacks are from the program currently being viewed on the
TV screen. To make recordings from this output, the
TV must be in normal full-screen mode rather than in
Split-Screen mode.
Back Panel 1
ANT 2/AUX
ANT 1/MAIN
(Located next to DIGITAL
AUDIO OUTPUT jack)
1
10
Chapter 1. Television Overview
7
2
• From this output you can record audio and video
signals from ANT 1, ANT 2, INPUT 1-3, and
IEEE 1394 devices.
• Digital signals from ANT 1, ANT 2, and IEEE
1394 devices are converted to analog video and
audio signals.
• Some signals cannot be recorded because of
copy-protection flags in the content.
• Video signals from devices connected to COM-
PONENT 1 & 2, HDMI 1 & 2 or PC DVI are
not available from these MONITOR OUTPUT
jacks.
6. HDMI/DVI AUDIO
Audio for HDMI 1 & 2: Use these analog audio inputs
when connecting DVI devices to the TV's HDMI jacks.
Unlike HDMI, DVI does not carry audio information on the
same cable. For analog audio from a personal com-
puter, use the PC-DVI AUDIO jacks instead.
19
6 5
4
3