Setting Country/Regional Codes; Using The Lcd Panel - Black Box MD1650A-JP Reference Manual

V.92 dialup 2-wire or 4-wire leased-line data/fax modem at commands

Hide thumbs Also See for MD1650A-JP:

Table of Contents

7. Setting Country/Regional Codes

Countries or regions vary in their requirements for how a modem functions. Therefore, you must configure

your modem to match the defaults of your country or region. Choose from any of the three methods:

• Using the LCD panel to set your country or region code.

• Using the global wizard to set your country or region code.

• Using AT commands to set your country or region code.

1. Start at the Status LCD and use ↓ to move down the menu tree to the Region Select LCD.

2. Use → to move from the Region Select LCD across the Region Settings Options LCD to the Current

Setting LCD.

3. If the current setting shown is not the one for your region, use the arrow keys to get to the Region Profile

LCD. The question mark represents the question: Is this the region you want? If B5 is the one you want,

press Enter; if it's not the one you want, use the arrow keys to get to the code you want. The region code

for Japan is 00.

4. When you reach the region code you want, press Enter. You will then see the message Option Set.

5. After setting the region profile, you can cycle the power to the modem (turn it off and then back on

again) or use the arrows to move back and up the menu tree to return to the Status LCD.

CHAPTER 7: Setting Country/Regional Codes

Table of Contents