Sony DSR-1500A Operating Instructions Manual page 36

36
Playback
To perform the following operations
Operation
Stop playback.
Adjust the audio playback
level.
Play back in shuttle mode
while monitoring the
a)
video.
Play back in jog mode while
a)
monitoring the video.
Inhibit the unit from
outputting text information
(time data, operation mode
indications, etc.) to the
video monitor.
Remove the cassette.
Disable the automatic
rewind function.
Change the time period
before the unit switches
from stop mode to standby
off mode.
a) When the SEARCH ENABLE menu item (see page 60) is set to ENABLE.
Do this:
Press the STOP button.
The unit enters stop mode, and will automatically
switch to standby off mode after the time set with the
STOP TIMER menu item (see page 64) for tape
protection.
For digital (optional DSBK-1501 required) or
analog audio output
Set the VAR switch on the front panel to PB and use
the REC/PB LEVEL control knob for each channel.
For outputs from the PHONES connector and
MONITOR connector
Use the PHONES control knob on the front panel
(outputs from the PHONES connector on the front
panel and the MONITOR connector on the rear panel
are adjusted).
To carry out a high-speed search (10 times normal
speed) in forward or reverse direction, press the G or
g button.
To return to normal-speed playback, press the PLAY
button.
Note
When performing these operations, set the LOCAL/
REMOTE switch on the front panel to LOCAL.
To carry out frame-by-frame playback in forward or
reverse direction, press the f or F button.
When you hold down the f or F button, playback is
1
−
/
continued in jog mode (
2
forward or reverse direction.
Note
When performing these operations, set the LOCAL/
REMOTE switch on the front panel to LOCAL.
Set the CHARA. DISPLAY menu item (see page 61)
to OFF.
Press the EJECT button.
If a CNT value is shown in the time counter display,
the CNT value is reset.
Set the AUTO REW menu item (see page 61) to
DISABLE.
Change the setting of the STOP TIMER menu item
(see page 64).
times normal speed
) in