TROUBLESHOOTING INSTRUCTIONS HEATING ISSUES Not heating: Overheating: LCD reads “Heating” LCD reads “Heating” Verify 220 volts between L1-L2 on the Verify that the resistance on the Temperature power block. If yes, proceed to #2. If no, Sensor is less than 10k ohms with a hot tank verify that the unit is plugged in correctly, (200+ degrees) If no, verify correct mounting and and that the panel breaker is turned on.
Page 8
Dump Valve. *Ensure that the sprayhead is free of mineral deposits, in good repair, and properly conected. Wilbur Curtis Co., Inc. 6913 Acco Street, Montebello CA 90640 Customer Service: 800.421.6150 | 323.837.2300 csrassistance@wilburcurtis.com Tech Support: 800.995.0417...