Lenovo thinkcentre e73 Hardware Maintenance Manual page 113

7. Remove the eight screws that secure the system board.
Figure 42. Removing the screws that secure the system board
8. Slide the system board to the front of the computer and then carefully lift the system board out of the
chassis. Place the failing system board on a flat, clean, and static-protective surface.
9. Remove the microprocessor from the failing system board and install it on the new system board. See
"Replacing the microprocessor" on page 105.
10. Install the new system board into the chassis by aligning the eight screw holes in the new system
board with the corresponding mounting studs on the chassis. Then, install the eight screws to secure
the system board.
11. Install the heat sink and fan assembly and connect the heat-sink-and-fan-assembly cable to the new
system board. See "Replacing the heat sink and fan assembly" on page 101.
Note: If necessary, apply the appropriate amount of thermal grease on the bottom of the heat sink
and fan assembly.
12. Install all memory modules and PCI Express cards removed from the failing system board onto the new
system board. See "Installing or replacing a memory module" on page 87 and "Installing or replacing a
PCI Express card" on page 84.
13. Refer to your record to connect cables to the new system board. You also can refer to "Locating
parts on the system board" on page 72 to help you locate the connectors on the system board and
connect cables.
14. To complete the replacement, go to "Completing the parts replacement" on page 121.
The failing system board must be returned with a microprocessor socket cover to protect the pins during
shipping and handling.
.
Chapter 9 Replacing FRUs (machine types: 10AS and 10AU)
109