Lenovo thinkcentre e73 Hardware Maintenance Manual page 110

To replace the microprocessor, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 82.
3. Lay the computer on its side for easier access to the system board.
4. Remove the heat sink and fan assembly. See "Replacing the heat sink and fan assembly" on page 101.
Note: Place the heat sink and fan assembly on its side so that the thermal grease on the bottom of it
does not get in contact with anything.
5. Lift the small handle
Figure 39. Accessing the microprocessor
6. Lift the microprocessor straight up and out of the microprocessor socket.
Figure 40. Removing the microprocessor
Notes:
106
ThinkCentre E73 Hardware Maintenance Manual
1
and open the retainer
2
to access the microprocessor
3
.