Getting Started; Welcome; Installation - bensat HDT913AEP Owner's Manual

GETTING STARTED

Welcome

If you use the STB for the first time, the "Welcome" menu appears.
Press cursor button to setup the Region, Language, Display Mode
and Aspect Mode.
Highlight "OK" and press the "OK" button to start channel search.

Installation

1
Press the "MENU" button to enter main menu.
2
Press "UP"or " DOWN " button to highlight "Installation", press
"RIGHT" button to enter the Installation menu.
3
Press "UP" or "DOWN" cursor button to highlight the desired item
and press "OK"button to enter the sub-menu .
4
Press "EXIT" button to exit.
Channel Scan
1
Select "DVBT Channel Scan", press the "OK" button to enter the
Channel Scan menu.
2
Press cursor button to set Scan mode, Scan Band ,Channel No.,
Frequency and Bandwidth, then highlight "Search", press "OK"
button to start channel scan .
Auto Scan
1
Select the "Auto Scan", press "OK" button to enter the Auto Scan menu.
2
Press the cursor button to set "FTA Only", then highlight "Search",
press the "OK" button to start auto scan .
LCN
If LCN( Logical Channel Number) Select function is activated, you can't change the original
number of TV channels by scanning .
You can activate/disactivate the LCN function by setting the "LCN " to on/off.
English
4 1
Welcome
Region Poland
Language English
Display Mode
720p_50
Aspect Mode 4:3LB
OK
Installation
Channel Scan
Auto Scan
LCN
Channel Scan
Scan Mode By channel
UHF
Scan Band
Ch No. CH37(666000KHz)
Frequency 666000KHz
Bandwidth 8MHz
Search
Signal Intensity
Signal Quality
Auto Scan
FTA Only No
Search
81%
97%