Table of Contents
Advertisement
Setup Procedure
1. Determine the installation location
CAUTION: DO NOT ATTEMPT TO INSTALL THE LCD MONI-
TOR BY YOURSELF.
Installing your LCD display must be done by a qualified
technician. Contact your dealer for more information.
CAUTION: MOVING OR INSTALLING THE LCD MONITOR
MUST BE DONE BY TWO OR MORE PEOPLE.
Failure to follow this caution may result in injury if the LCD
monitor falls.
CAUTION: Do not mount or operate the display upside down,
face up, or face down.
CAUTION: Portrait use is not guaranteed for this product.
CAUTION: Do not install the LCD monitor where it will be
exposed to direct sunlight, as this will result in
display defects.
CAUTION: This LCD has a temperature sensor and cooling
fan. If the LCD becomes too hot, the cooling fan
will turn on automatically. If the LCD becomes
overheated and the cooling fan is running, the
"Caution" menu will appear. If the "Caution" menu
appears, discontinue use and allow the unit to cool.
When the LCD monitor is used in an enclosure or
with protection on LCD surface, please check the
inside temperature of monitor by "HEAT STATUS"
(See page 27). The temperature is too hot than
normal condition, please set "cooling fan" to ON on
SCREEN SAVER function (See page 24).
IMPORTANT: Lay the protective sheet, which was wrapped around
the LCD monitor when it was packaged, beneath the
LCD monitor so as not to scratch the panel.
2. Install the remote control batteries
The remote control is powered by 1.5V AAA batteries. To install
or replace batteries:
1. Press and slide to open the cover.
2. Align the batteries according to the (+) and (–) indications
inside the case.
3. Replace the cover.
CAUTION
Incorrect use of batteries can result in leaks or bursting.
Be careful especially about the following points.
•
Place "AAA" batteries matching the + and - signs on each
battery to the + and - signs of the battery compartment.
•
Do not mix battery types.
•
Do not combine new batteries with used ones. It causes
shorter battery life or leakage of batteries.
•
Remove dead batteries immediately to prevent battery liquid
from leaking into the battery compartment. Don't touch ex-
posed battery acid, it cause damage to your skin.
NOTE: If you do not intend to use the Remote Control for a long
period, remove the batteries.
3. Connect external equipment (See page
13-17)
•
To protect the connected equipment, turn off the main power
before making connections.
•
Refer to your equipment user manual.
4. Connect the supplied power cord
•
The power outlet socket should be installated as near to the
equipment as possible, and should be easily accessible.
•
Fully insert the prongs into the power outlet socket. Loose
connection may cause noise.
NOTE: Please refer to "Safety Precautions, Maintenance &
Recommended Use" section of this manual for proper
selection of AC power cord.
Cable Holder
5. Switch on the power of all the attached
external equipment
When connected with a computer, switch on the power of the
computer first.
6. Operate the attached external equipment
Display the signal on the external equipment you wish.
7. Adjust the sound
Make adjustments when adjustment of the volume is required.
8. Adjust the screen (See pages 20-28)
Make adjustments when adjustment of the screen display
position or distortion is required.
9. Adjust the image (See page 20-28)
Make adjustments when adjustment such as the brightness or
contrast is required.
10. Recommended Adjustment
English-10
Hide quick links:
Advertisement
Table of Contents
