Table of Contents
Advertisement
Safety and Installation Instructions
All the devices distributed by us comply with the applicable safety regulations and are absolutely safe under normal use. Please
note the following instructions to avoid potential hazards, damage or malfunctioning:
Instructions for Installation Site
The emerging heat during operation must dissipate through adequate air circulation. Therefore the device should not be covered
or placed in a closed cabinet.
Make sure that the ventilation slots on device are not covered for e.g. with the newspapers lying on it, tablecloths or curtains. This
could possibly lead to fire equipment.
The heat generated by the device can cause colour change when comes in contact with furniture surfaces. If required place the
device on a suitable location.
Allow free space of minimum 10 cm around the device. Heaters or other heat sources near the device can cause malfunctioning
or damage to the device. No naked sources of fire are allowed, for e.g. burning candles placed on the device.
The place in the room should not be chosen with high humidity, e.g. kitchen, bathroom etc. where precipitation of condensed
water or splashing water leads to the damage of a device.
The device is intended for use in dry conditions and in a temperate climate.
If the unit is moved from a cold to a warm place, condensation may occur in the device. Therefore let the device to be switched off
for few hours.
13
Advertisement
Table of Contents
