Panasonic Touchbook CF-50 Series Reference Manual page 15

Security Measures
When you do not want the data on the hard disk to be read/written
When the Hard Disk Lock is set to [Enable], it is impossible to read/write data from/to
the hard disk when the hard disk is inserted in a different computer, since a password is
also set for the hard disk. When the hard disk is returned to the original computer, you
can read and write data as before. In this case, however, make the settings in the Setup
Utility exactly the same as they were before the hard disk was removed.
It is possible to set the Hard Disk Lock even if [Password on boot] is set to [Disable], but
we recommend that [Password on boot] be set to [Enable] for security reasons.
(Note that this Hard Disk Lock does not guarantee complete protection of data.)
NOTE
In the default setting, [Hard Disk Lock] is set to [Disable].
You cannot set the [Hard Disk Lock] without setting the Supervisor Password.
Set the Supervisor Password if you have not done so. (
The hard disk protection function only works with the internal hard disk. This
function does not work with the external hard disk.
Procedure
1
Run the Setup Utility
2
Using either
3
Using either
Enter
4
To enable the Hard Disk Lock
Select [Enable] and press
At the [Caution], press Enter .
To disable the Hard Disk Lock
Select [Disable] and press
5
Press F10 and select [Yes], then press Enter
CAUTION
To change your hard disk drive
To change your hard disk drive, contact Panasonic Technical Support.
Before changing the hard disk, be sure to set the [Hard Disk Lock] to [Dis-
able].
( page 41)
or , select [Security]
or , select [Hard Disk Lock] and press
Enter
Enter
15
page 13)