Download Print this page

Polarstart PS-5505TW User Manual

Advertisement

Quick Links

NOTES
8
INTRODUCTION
The PS-5505TW is a state-of-the-art combination of an alarm and remote car starter
with command confirmation. It represents a breakthrough in vehicle convenience
technology, and remote starter systems.
USER SELECTABLE OPTIONS
The PS-5505TW was designed with flexibility and OEM integration in mind. The unit
can be customized and used in almost every possible application.
With the integration of Timed, Latched, or ON/OFF outputs, this unit can single-
handedly control virtually any electrical system in your car.
NOTE: The programming of your system should be left to a professional. Changing
any of the settings may effect the operation of your PS-5505TW.
Please have your installer program the following options:
IGNITION CONTROLLED DOOR LOCKS
This feature will LOCK all doors once the brake pedal has been pressed for the
first time after starting the vehicle. When the key is turned to the OFF position,
the doors will be UNLOCKED.
REMOTE START RUN TIME
The PS-5505TW can be programmed by your installer to run the engine for 4, 15
or 25 minutes. The default run time is 15 minutes.
TRANSMITTER FUNCTIONS
Your PS-5505TW is equipped with a 5 button, 15 channel remote transmitter. It can
operate two independent Polarstart equipped vehicles. (See Multi-Car Operation for 2
car transmitter functions.)
The transmitter functions are as follows:
System Status
display Screen
ARM/LOCK
DISARM/
UNLOCK
STOP
START
TRUNK
1
nd

Advertisement

loading
Need help?

Need help?

Do you have a question about the PS-5505TW and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Polarstart PS-5505TW

  • Page 1 UNLOCKED. • REMOTE START RUN TIME The PS-5505TW can be programmed by your installer to run the engine for 4, 15 or 25 minutes. The default run time is 15 minutes. TRANSMITTER FUNCTIONS Your PS-5505TW is equipped with a 5 button, 15 channel remote transmitter. It can operate two independent Polarstart equipped vehicles.
  • Page 2 BEEPS DISABLED The transmitter display panel has 6 icons that will flash in red to display the successful You can disable the transmitter confirmation beeps by pressing the TRUNK button 5 operation of the command that has been requested. times (1 beep confirms that the beeps are disabled). To re-enable the beeps, press the TRUNK button 5 times again within 3 seconds (3 beeps confirm that the beeps are The 6 icons are displayed on the remote as follows: enabled).
  • Page 3 COLD WEATHER TIMER ALARM FUNCTIONS – To be programmed by your installer The PS-5505TW comes equipped with a Cold Weather Timer. When programmed, it will Your system can be programmed in Passive or Active Arming Mode. In either mode, start and run the engine every 2 hours for 5 minute intervals during a period of 24 hours.
  • Page 4 SYSTEM LED FLASH RATE REMOTE STARTER VALET MODE The PS-5505TW system comes with a full status LED to be mounted on your dash. The The system can be placed in Remote Starter Valet Mode. This disables the remote LED displays the status of the system. When you press the UNLOCK button, the LED state starting capabilities while maintaining the alarm and door locking/unlocking functions.