Table of Contents
Advertisement
Installation
Type-C : Connecting one touch type hose to tap without thread
Ring plate
Guide plate
‹¤Step3: Connect hose to washer
NOTE
• After completing connection, if water leaks from the hose, repeat the same steps.
Use the most conventional type of faucet for water supply. In case the faucet is square or
too big, remove the spacing ring before inserting the faucet into the adaptor.
Horizontal tap
12
1. Unscrew the adapter ring plate and
2. Remove the guide plate if the tap is
3. Push the adapter onto the end of
4. Pull the connector latch plate down,
Latch plate
• Make sure that there are no kinks in the
‹¤When your washer has two valves.
• The Inlet hose which has red connector is
• If the washer has two valves, the energy is
Please use the horizontal tap
Extension tap
the 4 adapter retaining screws.
too large to fit the adapter.
the tap so that the rubber seal forms
a watertight connection.
Tighten the adapter ring plate and
the 4 screws.
push the inlet hose onto the adapter,
and release the connector latch plate.
Make sure the adapter locks into place.
NOTE
• After connecting inlet hose to water
tap, turn on the water tap to flush
out foreign substances (dirt, sand or
sawdust) in the water lines. Let
water drain into a bucket, and
check the water temperature.
hose and that they are not crushed.
for the hot water tap.
saved by using hot valve.
Square tap
Advertisement
Table of Contents
