Toshiba MMU-AP0152SH Service Manual page 105

No. Part name
†
Control P.C. 1. Detachment
board
NOTE)
Be sure to unlock the lock of the housing before
removing the connector.
2. Attachment
NOTE)
For connectors, check there is no missing or
contact failure.
Procedure
1) Perform work of procedure 1. of
2) Remove connectors connected from the
control P.C. board to other parts.
CN33: Flap motor (5P: White)
CH34: Float switch (3P: Red)
CN41: Remote controller terminal block
(3P: Blue)
(Screws of terminal block: 4P)
CN67: Power supply terminal block
(2P: Black)
(Screws of terminal block: 2P)
CN68: Drain pump (2P: Blue)
CN82: PMV (6P: Blue)
CN100: TC1 sensor (3P: Brown)
CN101: TC2 sensor (2P: Black)
CN102: TCJ sensor (2P: Red)
CN104: Room temp. Sensor (2P: Orange)
CN333: Fan motor power supply
(5P: White)
CN334: Fan motor position detection
(5P: White)
3) Unlock the locks of the card edge spacers
(7 positions), and then remove the control
P .C. board.
1) Fix the control P.C. board to the card edge
spacers (7 positions).
2) Connect the connectors disconnected in
item 1 as before.
…
.
Power supply
terminal block 2P
105
Remarks
Card edge spacer
Remote controller terminal block 4P