Configuring Your Scanner; Preprogrammed Frequencies; Programming Channels - Whistler WS1010 Owner's Manual

CONFIGURING SCANNER

Preprogrammed Frequencies

Your scanner includes 153 preprogrammed
frequencies, which you can load into Channels 1 to 153.
For a list of these frequencies, see "Preprogrammed
Frequency List" on page 26.
To load the preprogrammed frequencies:
1. Turn off the scanner and then turn it on again.
2. While WELCOME message appears, press PGM.
3. Load –Fr– appears, then YES––Ent and No ––CLEAr
appear alternately.
4. Press ENT to load frequencies or CLEAR to cancel.

Programming Channels

If you do not have a list of frequencies in your area,
refer to www.radioreference.com.
1. Press PGM. PGM appears.
2. Enter the channel number (1–200) where you want
to store a frequency,
3. Press PGM again.
4. Use the number keys to enter
the frequency,
5. Press ENT.
6. To program the next channel
in sequence, press PGM and
repeat Steps 4 and 5.
• Your scanner
automatically rounds
down to the closest valid
frequency. For example,
if you enter 151.473, your scanner rounds it to
151.470.
• If Error appears and the scanner beeps three
times when you press ENT, start again from Step
2.
• If the frequency is already stored in another
channel, the scanner beeps three times and
displays -dUPL- (duplicate) and the lowest
channel number where the frequency is already
stored. Press
TUNE/CLEAR to cancel. Press ENT if you still
want to store the frequency.
1,3,6
14
2, 4
5