How To Set Up - JBSYSTEMS Light Beam Twister Operation Manual

ENGLISH
HOW TO SETUP:
MAIN MENU:
 To select any of the menu options, press the [MENU] button up to when the
required option is shown on the display.
 Select the function with the [ENTER] button. The display will blink.
 Use [DOWN & UP] button to choose the desired menu option.
 Once the required menu option is selected, press the [ENTER] button to
select.
 Press the [MENU] button for about 2 seconds to store the setting and to
return to running mode. If you don't do this, the setting will not be stored
and after about 8 seconds, the fixture will return to the previous running
mode.
DMX512 Address Setting
Used to set the start address in a DMX setup.
 Press the [MENU] button until
 Press the [ENTER] button to select.
 Use [DOWN & UP] buttons to change the DMX512 address.
 Once the correct address is shown on the display, press the [ENTER]
button to confirm.
 Press the [MENU] button for about 2 seconds to store the setting and to
return to running mode.
Channel Mode
The unit has 2 different channel modes. Refer to the DMX-chart to see
the differences.
 Press the [MENU] button until
 Press the [ENTER] button to select.
 Use [DOWN & UP] buttons to select one of the available channel modes.
 Once the mode is selected, press the [ENTER] button to confirm.
 Press the [MENU] button for about 2 seconds to store the setting and to
return to running mode.
/
Master Slave Mode
Used to set the fixture in master or in one of the slave modes. By
choosing the right slave mode you can improve the impact of the
shows.
 Press the [MENU] button until
 Press the [ENTER] button to select.
 Use the [DOWN & UP] buttons to select "master", slave mode 1 or slave
mode 2.
 [MASt]: this unit will run its integrated programs and will control the slave fixtures that are connected to
this unit
 [SL I]: the device will run 100% sinchronously with the master device.
 [SL 2]: the device will run sinchronously with the master device, but from time to time the effects will be
inverted to create more diversity in the show.
 Once the right mode is selected, press the [ENTER] button to confirm.
 Press the [MENU] button for about 2 seconds to store the setting and to return to running mode.
JB SYSTEMS
®
is shown on the display.
is shown on the display.
is shown on the display.
5/50
USER MANUAL
BEAM TWISTER