Setup Menu; How To Enter The Setup Menu To Change Settings - Aprilaire 8820 Owner's Manual

WI-FI MAINTENANCE AND TROUBLESHOOTING
Wi-Fi connection status Radio status indicator
Normal Operation .
Wi-Fi signal strength is indicated
by the appropriate number of bars .
The thermostat Wi-Fi settings have not been The frame is displayed and the bars cycle
entered . Refer to Wi-Fi Setup on pages 6-7 for from 0 to 4 .
instructions for entering the Wi-Fi settings .
The thermostat cannot connect to the Wi-Fi router . The frame and all bars
Verify that the router is functioning properly . flash on and off .
Indicates the thermostat was not configured The display will alternate between displaying the
properly when connecting to the router . Confirm frame and all bars .
there is no IP conflict and repeat Wi-Fi setup .
Note: If the thermostat is configured to work
with an Aprilaire account this indicates that the
thermostat cannot connect to the Aprilaire Cloud .
Confirm that the internet connection is working .
There is an internal error with the thermostat
The frame will flash on and off .
Wi-Fi radio . The thermostat will continue to
control the HVAC and indoor air quality control
equipment, but will not be able to connect to
Wi-Fi . Contact an HVAC professional for repair .
Wi-Fi radio turned off . Refer to the Setup Menu Not displayed .
section for information about turning the Wi-Fi
module on .
34

SETUP MENU

HOW TO ENTER THE SETUP MENU TO CHANGE SETTINGS

Message Center
No corresponding message
Press [MENU] to enter the main menu .
Press [SETUP] to enter the setup menu .
Displays the SSID of the
thermostat . Note: The SSID
will be used to identify the
thermostat when using a
smart device to connect the
thermostat to your Wi-Fi router .
WiFi Connection Lost
Internet Connection Lost
Press [Next] or [Back] to page through the settings
(the setting is displayed in the message center) .
Radio Error
WiFi Turned Off
Press or to adjust the setting . (Selected option
flashes .)
Press [DONE] to save and exit, Or [CANCEL] to exit
without saving .
The thermostat will discard changes and exit if nothing
is pressed within 60 seconds .
MESSAGE CENTER
(SCROLLING TEXT)
35