Installation Of The Feet - Mirage OM DESIGN SERIES Manual

om design series manual
8.0 installation of isolation feet (omd-28 only)
Once you have completed the fine-tuning process and
have found the ideal position for the speakers in your
room, you are ready to install the feet of the OMD-28.
In the accessory case you will find four machined
aluminum feet.
In order to install the feet, please follow these two
easy steps:
NOTE: TWO PERSONS ARE REQUIRED IN ORDER TO
SAFELY INSTALL THE FEET OF THE OMD-28.
1. With one person securely holding the OMD-28
cabinet in place, slightly tip the cabinet towards
that person so that the bottom of the base is
partially exposed
2. The other person can now screw the feet into one
of the four the threaded inserts found at the
bottom of the base
Repeat these steps until all four feet are securely
installed.
3. The feet can now be used to precisely level the
speaker. Simply unscrew the foot to level the
cabinet and then rotate the large washer so that it
is snug against the cabinet, NOT the cone foot
itself! This will securely lock the foot in position
and will not allow it to "rock" on its threads.
15