Firstech 700R Quick Start Card page 2

Tap these buttons to activate ignition controlled door locks. Your
doors will lock or unlock when you turn the key on or off. If you have
a remote start, your doors will lock when you press the foot brake.
ALARM LED CODES
If you have an alarm and optional LED(s) installed, it will flash once
a second if armed. If your alarm is triggered then the LED(s) will flash
more than once until it is disarmed. See the table below for what
each LED code represents.
ALARM TRIGGER EVENT
Door, Hood, Trunk, or Ignition On triggered
Full triggered shock sensor
Panic Mode
Valet Mode: If your remote start is not working, you may be in Valet
Mode. Your parking lights will also not flash. Your doors will still
lock and unlock. To exit Valet Mode, tap the Lock and Trunk buttons
at the same time.
700R-600R _QuickCard line.indd 2
QUICK START CARD
LED FLASHES
2, Pause, Then Repeat
3, Pause, Then Repeat
5, Pause, Then Repeat
START ERROR CODES
PARKING LIGHT FLASHES
3 then 1 1: Motor running
3 then 2 2: Key in ignition on position
3 then 5 5, Foot brake on
3 then 6 6: Hood open
3 then 8 8: Tach or voltage sensing failure
3 then 10 10: System is in Valet Mode
To reprogram your remote first cycle the key in the ignition 5
times within 7 seconds. Parking lights will flash. After that tap
the Lock button on your remote. Repeat for any additional
remotes. If you receive two parking light flashes, your system
has exited remote programming mode and you must retry.
Register online at www.compustar.com within 10 days of
purchase to activate your new remote's warranty.
Questions/comments? Contact us at 888-820-3690 from 8
AM to 5 PM PST. Also please visit www.compustar.com for a
complete user's manual.
700R - 600R
REMOTE START ERROR
Firstech, LLC. | 2
2013/6/6 9:02:11