Remote Control - Honeywell HL10CESWW User Manual

USE & OPERATION (CONTINUED)

REMOTE CONTROL

The functions work the same as the portable air conditioner's Control Panel.
All key functions can be accessed from the remote control.
Mode Control
Press this button to change the
operation mode
COOL
FAN
Timer Control
In running mode: Auto switch OFF
In stand-by mode: Auto switch ON
Press ▼ or ▲ button to adjust the
time setting for 1 hour intervals
Note:
• Battery Installation: Remove the cover on the back of the remote control and insert two AAA batteries
with + and - pointing in the proper direction according to the polarity markings.
Caution:
• Use only two AAA or IEC R03 1.5V batteries.
• Remove the batteries if the remote control is not in use for a month or longer.
• All batteries should be replaced at the same time, do not mix with old batteries.
• Properly dispose of used batteries.
This device complies with part 15 of the FCC Rules. Operation is subject to following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.
Power Control
ON / OFF
DRY
HEAT*
EN
Temperature / Timer Set
• Used for adjusting the timer and temperature
• When the ▼ or ▲ key is pressed, the set
temperature is displayed and may be adjusted.
After 5 seconds the display will revert back to
room temperature
Timer setting is from 1-24 hours by pressing
•
the ▼ or ▲ keys
Fan Speed Control
• HIGH • MID • LOW
Sleep Control
ON / OFF
*Applicable for models with Heating feature only.
7