Advertisement
-This light should be keep away from strong shaking during any transportation or movement.
-Don't pull up the light by only the head, or it might cause damages to the mechanical parts.
-Don't expose the fixture in overheat, moisture or environment with too much dust when installing
it. And don't lay any power cables on the floor. Or it might cause electronic shock to the people.
-Make sure the installation place is in good safety condition before installing the fixture.
-Make sure to put the safety chain and check whether the screws are screwed properly when
installing the fixture.
-Make sure the lens are in good condition. It's recommended to replace the units if there are any
damages or severe scratch.
-Make sure the fixture is operated by qualified personnel who knows the fixture before using.
-Keep the original packages if any second shipment is needed.
-Don't try to change the fixtures without any instruction by the manufacturer or the appointed
repairing agencies.
-It is not in warranty range if there are any malfunctions from not following the user manual to
operate or any illegal operation, like shock short circuit, electronic shock, lamp broke, etc.
4. 4. 4. 4. Mounting
Mounting
Mounting
Mounting and
and
and
and Installation
Installation
Installation
Installation
Cautions: For added protection mount the fixtures in areas outside walking paths, seating areas,
Cautions:
Cautions:
Cautions:
or in areas were the fixture might be reached by
unauthorized personnel.
Before mounting the fixture to any surface, make sure that the installation area can hold a
minimum point load of 10 times the device's weight.
Fixture installation must always be secured with a secondary safety attachment, such as an
appropriate safety cable.
Never stand directly below the device when mounting, removing, or servicing the fixture from a
ceiling, or set on a flat level surface (see illustration below). Be sure this fixture is kept at least
0.5m (1.5 ft) away from any flammable materials (decoration etc.).
Always use and install the supplied safety cable as a safety measure to prevent accidental
damage and/or injury in the event the clamp fails.
Mounting
Mounting
Mounting
Mounting points:
points: Overhead mounting requires extensive experience, including amongst others
points:
points:
calculating working load limits, a fine knowledge of the installation material being used, and
160-179
180-199
200-219
220-255
0-127
Gobo 1
128-189
7
5
5
Rot.
190-193
194-255
0-009
010-019
020-029
030-039
040-049
050-059
060-069
070-079
080-089
090-099
8
6
6
Gobo 2
100-111
112-123
124-135
136-147
148-159
160-171
172-183
184-195
196-207
208-255
0-031
032-063
Gobo 5 shake slow to fast
Gobo 6 shake slow to fast
Gobo 7 shake slow to fast
Rot. gobo wheel cont. rotation slow to fast
Gobo indexing
Forwards gobo rotation from fast to slow
Gobo rotation stop
Backwards gobo rotation from slow to fast
Open/hole
Gobo 1
Gobo 2
Gobo 3
Gobo 4
Gobo 5
Gobo 6
Gobo 7
Gobo 8
Gobo 9
Gobo 1 shake slow to fast
Gobo 2 shake slow to fast
Gobo 3 shake slow to fast
Gobo 4 shake slow to fast
Gobo 5 shake slow to fast
Gobo 6 shake slow to fast
Gobo 7 shake slow to fast
Gobo 8 shake slow to fast
Gobo 9 shake slow to fast
Gobo wheel rotation from slow to fast
Shutter closed
shutter open
Advertisement
