V2GO g0-210 User Manual page 27

3.REAR
Select ON to enable left
surround (SL) and right
surround (SR) channels.
Select OFF when standard
stereo has been selected.
5.CENTER DELAY 5.CENTER DELAY
Use to select the delay time of
the center signal output.
7.TEST TONE 7.TEST TONE
In the 5.1 CH mode (surround sound) the Test Tone is used to test each of the
connected speakers. The left corner of the connected video monitor will
graphically display each speaker as it is sequentially tested. Select OFF to end
the test.
Audio Setup Audio Setup
1.SPDIF OUTPUT 1.SPDIF OUTPUT
This sets the optical and coaxial digital outputs to ON or OFF.
Set to OFF if no digital or optical devices are connected.
Set to SPDIF/RAW when connected to an amplifier with Dolby decoding.
Set to SPDIF/PCM when using a stereo amplifier to play Dolby digital discs.
2. DUAL MONO 2. DUAL MONO
Use to select STEREO
OUTPUT, L-MONO output,
R-MONO output or MIX-
MONO output. MIX-MONO
results in a mono audio
signal sent to both the R
and L speakers.
4.PRO LOGIC 4.PRO LOGIC
Use to turn the built-in
Dolby decoder ON or OFF.
The AUTO setting
automatically selects the
disc format.
27
4.SUBWOOFER
Select ON to enable
subwoofer speaker
output. Select OFF
when standard stereo
has been selected.
6.REAR DELAY 6.REAR DELAY
Use to select the delay
time of the SL/SR
output to match the
placement of the center
speaker.
3.COMPRESSION
Use to control acoustic
highs and loud portions
of an audio track
(example: a war movie
with bombs exploding
and then with people
whispering in the next
scene). This control
dynamically lowers the
volume and still keeps
the original quality of the
audio track.
5.LPCM OUTPUT 5.LPCM OUTPUT
Use to select personal
preferences of audio
timbre.