Configuring Emergency Operation - HDG Compact 25 Operation Manual

8 Troubleshooting – Configuring emergency operation

8.3 Configuring emergency operation

R
EQUIREMENTS
P
ROCEDURE
F
URTHER MEASURES
158
If the remedy to your problem is listed in "Table 8/1 - Faults" as
"Configure emergency operation", you activate emergency
operation on the control unit of the HDG Compatronic as follows.
1. Press the Enter button.
Enter
✓
The customer level is shown on the display.
✓
The cursor is positioned on the parameter group 1-General.
2. Press the Enter button again.
Enter
✓
This takes you to the parameter group 1-General.
3. Press the Down button twice.
✓
The display will change to General 1-04.
4. Press the Enter button.
Enter
✓
The cursor will flash underneath the value 0.
✓
The displayed value can now be changed.
5. Press the Plus button.
✓
The value of the parameter is increased to 1.
6. Press the Enter button.
Enter
✓
The changed value is confirmed.
✓
Emergency operation has been configured.
7. Press the Menu button twice.
Menu
✓
The standard display of i-01 is shown.
Have the fault fixed by an authorised heating technician.