Options At A Glance; Additional Information; Adding A Forgotten Item; Storing - Jenn-Air DW731 Manual

Options At A Glance Additional Information
Heating Options
(Located
on buttons on
theleftside ofthepanel.)
A
d d i n g a F o r g o t t e n I t e m
For best cleaning, the forgotten item should be added early
FAN DRY HEAT improves drying results by turning the in the cycle.
heating element on during a portion of fan dry.
1. Unlatch the door and wait until the sound of circulating
FAN DRY AIR turns the heating element off during the water stops.
fan dry portion of the cycle. Towel drying of some items
may be necessary. 2. Open the door and add the item.
I Note: With either dry option, it is normal to notice 3. Close and latch the door. The cycle will continue at the
vapor coming out of the vent area. point it was interrupted.
ACCU TEMP checks the main wash and final rinse water C I e a n i n g
temperatures and will extend the heating and water circu- Clean the control panel and front panels with a lightly
lation until proper water temperature is reached, dampened cloth. Dry thoroughly. Do not use abrasives or
SANI WASH (Select models only) turns the heating ele- sharp objects on the panel. They can damage it.
merit on during all wash and rinse portions of the cycle. It The inside normally takes care of itself. Occasionally
checks the main wash and final rinse water temperatures check the tub bottom for any large pieces which may have
and will extend the heating and water circulation until collected. Periodically clean the edge of the door liner and
proper water temperature is reached. This option does not gasket if any food spills are noticed.
sanitize the dishes.
To remove any odor, try one of the following:
RESET (Select models only) can be pressed to cancel all , Put baking soda in both cups. Select the normal cycle
heating options, and let the water circulate for about 10 minutes. Unlatch
POTS & PANS (Seleet models only) adds water temper- the door and let it sit overnight. Then relatch the door
and let the cycle finish.
ature checks to the main wash and final rinse for proper
cleaning and drying results. , Select the Normal cycle and let the dishwasher fill with
water. Then open the door and pour 1 cup of chlorine
I n
d
i c a t o r L
i gh
t s
bleach into the bottom of the dishwasher. Latch the door
{select models}
and let it complete the cycle.
, Try a lemon scent detergent and/or rinse aid to help peri-
ON - The on light will glow during all washes, rinses and odically freshen the dishwasher interior.
the drying periods.
• Run the dishwasher more frequently. Use the Rinse &
DELAY START- The Delay Start light will glow during Hold cycle (if available) to remove any food soil that
the Delay time period. It will go off when the dishwasher may cause an odor.
starts.
CLEAN - The Clean light will glow after the drying peri- S
t
o r
i n g
od is completed as a reminder that the dishes have gone
through a wash and dry cycle. It will remain lit until tile If your dishwasher will be in storage or an unheated area
dial is manually turned to the Off position, exposed to freezing temperatures:
t HEAT DELAY - The Heat Delay light indicates the * Clean the dishwasher as explained above.
cycle is being extended to heat the water to the proper tern- , Operate the drain portion twice to ensure most of the
perature, water is removed. Most dishwashers begin each cycle
with a drain. For touch control models, press the
DraildOff pad.
Disconnect the electrical supply and prop open the door.