Using The Unit In Other Countries / Listening To Other Portable Audio Devices / Sleep Operation - iHome iDL44 User Manual

3. To memorize a station as a preset:
A. Press the Radio Presets Button as needed to step through the 6 presets (P1 - P6) to the number you wish to
assign, and then hold the Radio Presets Button until the selected preset number begins flashing in the display and
a beep sounds.
B. Press the + or – Button to tune the radio to a desired station. Hold briefly to have the radio autoscan/search for the
next clear station.
C. Press the Radio Presets Button. Two beeps will confirm the station is assigned to the preset number you selected.
Repeat steps A-C to preset up to 6 stations.
4. To listen to a preset station, press the Radio Presets Button to choose the desired preset.
5. Press the or Button on the unit to adjust the system volume.
Different regions of the world use different FM radio frequency steps and ranges. You will need to select the one that
matches the standards in your region (USA, EUROPE, JAPAN, AUSTRALIA, or CHINA). The default setting is USA; if you
live in the US, you may skip this section.
1. Make sure the unit is OFF (not playing in any mode). Press and hold the Mode Button for about 5 seconds until "Radio
USA" appears in the lower part of the display and a beep sounds. Press and release the + or – Button to set the
frequency steps to match your region.
2. Press and release the Mode Button again (or no button within 10 seconds) to exit the radio frequency setting mode.
Two beeps will confirm radio frequency setting.
You can play any audio device equipped with a headphone jack through the iDL44 via the Aux-in Jack.
1. Connect one end of a standard 3.5mm stereo audio cable (not included) to the headphone or line-out jack on your
device and connect the other end into the Aux-in Jack, located on the back of the unit.
2. Press and release the Mode Button as needed until "AUX-IN" appears in the lower part of the display, indicating Aux-in
playing mode.
3. Turn on and play your device.
4. Press the or Button on the unit to adjust the system volume. You may need to adjust your device volume, too.
Remember to turn off your device when you are done playing it.
Sleep mode lets you sleep to whatever is currently playing (iPad/iPhone/iPod or the radio), gradually lowering the volume
until the unit shuts off at the selected time.
1. Press the Sleep Button to enter sleep mode. The current sleep time will appear on the display.
2. You can adjust the sleep timer from 120, 90, 60, 30, 15 minutes or OFF turns unit off) by pressing the Sleep Button
again.
3. When the display changes back to show the real time, pressing the Sleep Button once will show the sleep time
remaining. Pressing it again will change sleep time to next lowest increment.
4. iDL44 has independent volume setting for sleep mode so you can adjust the sleeping volume without affecting the
alarm volume. Press the
at that level the next time you enter sleep mode until controls are changed.
5. To stop listening at any time, press the Power Button on the unit to turn it off.
Using the Radio in Other Countries
Listening to Other Audio Devices
Sleep Operation
or Button on the unit to adjust the system sleep volume. The sleep volume will remain
6