Crossover Settings - JVC KD-X330BTS Instruction Manual

AUDIO SETTINGS
(For KD-X33MBS)
Setting on
[SPK/PRE OUT]
FRONT
REAR/REAR Front speakers
(default) output
REAR/SUB.W ( Not available )
SUB.W/SUB.W Front speakers
output
Connection via speaker leads
For connections without using an external amplifier. However, with this
settings you can also enjoy the subwoofer output.
Setting on
[SPK/PRE OUT]
REAR/REAR Rear speakers output
REAR/SUB.W Rear speakers output
SUB.W/SUB.W Subwoofer output
If [SUB.W/SUB.W] is selected:
– [FRQ 120HZ] is selected in [SUB.W LPF] and [THROUGH] is not available.
– [R02] is selected in [FADER] and selectable range is [R15] to [00].
22
JS_JVC_KD_X330BTS_X33MBS_K_EN_2.indd 22
Audio signal through lineout terminal
REAR
Rear speakers output Subwoofer output
( Not available ) ( Not available )
L (left): Subwoofer output Subwoofer output
R (right): (Mute)
( 33 )
Audio signal through rear speaker lead
L (left) R (right)
Rear speakers output
Rear speakers output
(Mute)

Crossover settings

Below are the available setting items for 2-way crossover and 3-way
crossover.
SW
Caution
Select a crossover type according to how the speakers are connected.
( )
33
If you select a wrong type:
• The speakers may damage.
• The output sound level may be extremely high or low.
SPK SIZE (speaker size)
Selects according to the connected speaker size for optimum
performance.
• The frequency and slope settings are automatically set for the
crossover of the selected speaker.
• If [NONE] is selected for [TWEETER] of [FRONT], [REAR] and [SUBWOOFER] for
[SPK SIZE], the [X ' OVER] setting of the selected speaker is not available.
X ' OVER (crossover)
[FRQ]/ [HPF FRQ]/ [LPF FRQ]:
Adjusts the crossover frequency for the selected speakers (high pass
filter or low pass filter).
• If [THROUGH] is selected, all signals are sent to the selected speakers.
[SLOPE]/ [HPF SLOPE]/ [LPF SLOPE]:
Adjusts the crossover slope.
• Selectable only if a setting other than [THROUGH] is selected for the
crossover frequency.
[PHASE]:
Selects the phase of the speaker output to be in line with the other
speaker output.
[GAIN LEFT]/ [GAIN RIGHT]/ [GAIN]:
Adjusts the output volume of the selected speaker.
13/10/2015 1:44:53 PM