Technics SU-C550 Operating Instructions Manual page 20

Connections
Network settings
Using the WAC (Wireless Accessory
Configuration)
"WAC Mode for iOS"
You can send its Wi-Fi configuration to this
system using an iPhone/iPad/iPod touch.
• Supported device:
iPhone/iPad/iPod touch (iOS version 7.0 or
later), or Mac (OS X 10.9 or later, with AirPort
Utility 6.3.1. or later)
• The following explanations are based on an
iPhone.
• Make sure your iPhone is connected to your
home wireless network beforehand.
1 Press [ ], [ ] on the remote control
to select "WAC Mode for iOS" and
then press [OK].
• "Setting" is displayed.
2 Go to Wi-Fi settings on your iPhone.
3 Select "Technics SU-C550
under the "SET UP NEW AIRPLAY
SPEAKER..." on your iPhone.
• " ****** " stands for a character that is
unique to each set.
4 The "AirPlay Setup" screen appears
on your iPhone.
• This system will be displayed as "Technics
******
SU-C550
enter a new name to replace the existing
one. You can also do the renaming after the
network connection is set up. ( 23)
• You can set a password for this system
under "SPEAKER PASSWORD". (You will
need this password if you make network
settings by internet browser next time.)
5 Select "Next" to apply the settings.
• "Linking" is displayed.
• When the connection is established,
"Success" is displayed.
- "Fail" may be displayed if the connection
was not complete. Try this method
again from [SETUP] menu. If "Fail" is still
displayed, try other methods ( 19).
6 Press [OK] on the remote control to
exit the setting.
• "
" is displayed.
20
(Continued)
"
******
". To change the name,
Using the WPS button
"WPS Push"
If your wireless router supports WPS, you can
set up a connection by pressing the WPS button.
• A compatible wireless router may have the
WPS identifier mark.
1 Press [ ], [ ] on the remote control
to select "WPS Push" and then press
[OK].
• "WPS" is displayed. Complete step 2 within
2 minutes.
2 After "WPS" is displayed, press the
WPS button on the wireless router.
Example:
• "Linking" is displayed.
• When the connection is established,
"Success" is displayed.
- "Fail" may be displayed if the connection
was not complete. Try this method
again from [SETUP] menu. If "Fail" is still
displayed, try other methods ( 19).
3 Press [OK] on the remote control to
exit the setting.
• "
" is displayed.