Related Manuals for Technics SU-C01
Summary of Contents for Technics SU-C01
-
Page 1: Operating Instructions
Stereo Preamplifier SU-C01 SU-C01K OPERATING INSTRUCTIONS SU-C01 K is different in appearance and color-tone. Before operating this unit, please read these instructions completely. - Page 2 CONTENTS • BEFORE USING THIS UNIT •FRONT PANEL CONTROLS AND ......• FOR UNITED KINGDOM THEIR FUNCTIONS .
- Page 3 Dear Stereo Fan...
- Page 4 FOR LONG AND SAFE USE OF THIS UNIT (continued) TURN OFF AFTER USE AC OUTLETS ON REAR PANEL (NOT EQUIPPED FOR SOME COUNTRIES) If the unit is left for a long time with the power on, this will not only shorten its useful operation life, but may also cause Any equipment connected here should have •...
- Page 5 NEVER USE ALCOHOL OR PAINT THINNER AVOID SPRAY-TYPE INSECTICIDES Insecticides might cause cracks or "cloudiness" in the These and similar chemicals should never be used to clean cabinet and plastic parts of this unit. The gas used in such the cabinet, because they may damage the finish. sprays might, moreover, be ignited suddenly.
- Page 6 FRONT PANB.. CONTROLS AND THEIR FUNCTIONS 0 "push on" switch {for United Kingdom) "power stand-by • on" switch <.0 8 Tone controls $ High-filter switch 0 Subsonic filter switch 0 Loudness switch tape monttor '""" " high , IUt'IIOr c htler kx :tness 0 Input selector 8 Tape-monitor switch «!) Volume control...
- Page 7 8 High-filte.r switch (high filter) Note: (.a�..a) If a moving-coil type of cartridge is used with the input Set this switch to the "on" position to eliminate selector set to the "phono MM" position, the volume such high-frequency noises as "scratch" noise caused by dirt and dust on discs, "hiss"...
-
Page 8: Troubleshooting Guide
The information shown in this table is based upon the use of symptoms of malfunction not described in this table, it is recom this unit in combination with the Technics SE-C01 and mended that you consult the store where this unit was purchased ST-C01. - Page 9 Probable cause(s) Suggested remedy Problem Such noise is called ignition noise, and occurs • Relocate the antenna and the connection wires An unusual "popping" leading to it to a place farther away from where auto- noise is heard when while the automobile engine is running. mobiles pass.
-
Page 10: Technical Specifications
TECHNICAL SPECIFICATIONS (DIN 45 500) AMPLIFIER SECTION Total harmonic distortion 0.003% TUNER, AUX, TAPE (at 3V output and max. volume) 0.005% PHONO MM, MC (at 3V output and -20 dB volume) Input sensitivity and impedance PHONO MM 2.5 mV/47kO 100 jJV/470 150 mV 47k0 TUNER, AUX 150 mV 47k0... - Page 11 MEMO...
- Page 12 Matsushita Electric Trading Co., Ltd. PO. Box 288, Central Osaka Japan Printed in Japan SQX50577-1 F0379M1...