Basic Operations; Startup; Standby - Orion Technology 320LEDK User Manual

remote control and the reception window, or normal operation may be interfered.
2. Protect the remote control against violent vibration. Do not put or use the remote control in
direct sunlight, or the heat could cause it to deform.
3. The remote control may not work if the reception window is exposed to direct sunlight or strong
light. Please change the direction of the light or product, or get closer to the reception window
to operate the remote control.
4. Low battery voltage could lead to a shorter remote control distance. Please replace the battery
soon. If the remote control is to be kept idle for a long time, please remove the battery to avoid
the corrosion to the remote control caused by battery leakage.
5. Do not use batteries of different types or mix new batteries with old ones. Always replace the
batteries in pairs.
6. Do not put the batteries in fire, or charge or disassemble them, or charge, short circuit,
disassemble, heat or burn used batteries. Please dispose of waste batteries in accordance with
local environmental regulations.
VI. Basic Operations

Startup

Insert the power plug into the power socket, press the " " key on the control panel to turn on the
monitor; or press the "Standby" key on the remote control to turn on the monitor.

Standby

Press the "Standby" key on the remote control to enter the standby state.
★ Tips
The product adopts the energy-saving technology:
① If no signal is input in On state, the monitor will enter the standby state automatically after
about 5 min;
② When the auto power-off time arrives, the product will enter the standby state automatically;
③ If it is required to disconnect from the power completely, remove the power plug;