Emerson Avocent HMX Installer/User Manual page 27

b. Since isochronous USB devices are not supported in an HMX extender system, select to
receive Isochronous Endpoint OSD Alerts if one is connected.
c. Select to allow an isochronous endpoint to be attached to the system to allow control
information to be exchanged with that device.
3. In the Port Reservation section, map the four receiver USB connections to a specific USB port
reserved on the transmitter.
4. In the Advanced features section, select the Enable advanced features checkbox if you wish
to add information to this area of the page. This section allows you to enter special codes that
may be needed to resolve an issue if a USB device fails.
5. Click Update Now to apply your changes.
To configure receiver security settings:
1. Select Security on the left side of the page.
2. Data passed across the system can be USB data or control data (video data is not encrypted).
Click the desired radio button next to the Encryption field.
3. If you wish to require your password to open configuration pages, select the Secure web
pages with password checkbox.
4. If your password needs to be changed, select the Change password checkbox.
5. Enter the old password once, then enter the new password twice to verify.
6. Click Save to confirm your changes.
System Configuration Utility..... 23