How To Use The Hr085 Remote Control - McIntosh C47 Owner's Manual

Hide thumbs Also See for C47:

Connection diagram (2 pages)

Owner's manual (42 pages)

Table Of Contents

Table of Contents

How to use the Remote Control

The supplied C47 Remote Control (HR085) is capable

of directly controlling the functions of contemporary

McIntosh Source Components connected to the C47

via the Data Ports.

Notes: 1. If at any time the C47 seems unresponsive to

the HR085 Remote Control Commands, press

the

DEVICE Push-button to select

first.

2. For additional information on using the

HR085 Remote Control with the McIntosh

Model, please refer to the "How to Operate"

starting on page 20.

3. For additional information on assigning the

Data Ports, refer to "How to Setup" on page

16.

Trim

Press the TRIM Push-button until the desired Trim

function (Balance, Trim Level, etc.) appears on the

C47 Front Panel Display, then press the LEVEL Up or

Down Push-button to adjust the Trim setting.

Note: Press the TRIM Push-button to recall the last Trim

function selected. For additional information on

using the Trim Functions refer to "How to Oper-

ate" page 20.

Output Selection

Press the BLUE (Setup) Push-button followed by

the AM (Output 1) or FM (Output 2) Push-button, to

control the Rear Panel Audio OUTPUTS 1, 2 (ON or

OFF) and Power Control TRIG 1 / TRIG 2.

Note: For additional information on assigning the Out-

puts (1 and 2) and Power Control Triggers (1 and

2) refer to page 16.