Toshiba e-studio 2802a Safety Information Manual page 15

.
Do not damage, break or attempt to repair the power cord.
The following things should not be done to the power cord.
- Twisting it
- Bending it
- Pulling it
- Placing anything on it
- Heating
- Situating it near radiators or other heat sources
This could cause a fire or give you an electric shock. If the power cord is damaged, contact
your service representative.
Do not install the equipment by yourself or try to move it once it has been installed. This could
result in an injury or damage to the device. Contact your service representative if the
equipment needs to be installed or moved.
The socket outlet shall be near the equipment and be easily accessible.
Pull out the plug from the outlet more than once a year to clean around the prongs.
Accumulating dust and dirt could cause a fire due to the heat released by electric leakage.
Avoid placing the equipment in a place unsuitable for its weight and also make sure the
surface is level. Remember that if the equipment falls over, serious injuries could result.
Weight of the equipment is as follows;
e-STUDIO2802A: approx. 21.0 kg (46.3 lb.)
e-STUDIO2802AM: approx. 25.0 kg (55.1 lb.)
e-STUDIO2802AF: approx. 26.0 kg (57.3 lb.)
e-STUDIO2309A/2809A: approx. 26.0 kg (57.3 lb.)
(e-STUDIO2802A/2802AM/2802AF) When moving the equipment, pull out the drawer and
then have two or more persons hold the portions indicated below. If not, this could cause
malfunctioning or an injury.
When removing the plug from the outlet, do not pull the power cord. Always hold the plug
when removing it from the outlet. If the power cord is pulled, the wires may break and this
could cause a fire or give you an electric shock.
Make sure that the ventilation holes are not blocked.
If the temperature within the Multifunctional Digital Systems becomes too high, a fire could
result.
When connecting the interface cable to the equipment, be sure to turn the power OFF. If the
power is not turned off, you could get an electric shock.
Safety Information 13 (GB)
GB