Table of Contents
Advertisement
F E A T U R E S E T U P
Feature Summary (cont'd)
Feature/System Announces
Remote Access Code
"Remote access code is... "
Priority Call Code
"Priority call code is... "
Announcement Monitor
Number Announce
(Please see NOTE below.)
Store Number
(Please see NOTE below.)
Accept Blocked Calls
(Please see NOTE below.)
NOTE: For this feature to work, you must subscribe to Caller Identification service
from your telephone service provider. There is a fee for this service, and it may not be
available in all areas.
Options
Change the Remote Access Code to any three digit
number from 500 to 999. Do not set to same number
as Priority Calling Code.
• The Remote Access Code, preset to 500, allows
you to access many features of this answering
system remotely from a touch tone phone.
• The system will prompt you to repeat Steps 2
and 3 of Feature Setup until you have set all
three digits.
Change the Priority Call Code to any three-digit
number from 500 to 999. Code is preset to 999.
Do not set to same number as Remote Access Code.
See "Priority Call Code" under OPERATION for
information about using this feature.
Choose ON to hear the announcement when your
system answers a call. Choose OFF to have it
silent on your end. (Your caller will still hear the
announcement.) Announcement Monitor is preset
to ON.
NOTE: Volume must be set to a level you can hear
to use Announcement Monitor.
When this feature is on, the system will announce
the caller's telephone number between the second
and third rings. Number Announce is preset to OFF.
NOTE: When the Number Announce feature is on
and Number of Rings is set for two rings or Toll
Saver 2/4, the unit will answer after three rings to
allow enough time for the system to announce the
caller's telephone number.
When this feature is on, the system announces the
caller's telephone number when it plays back a
message. Store Number is preset to OFF.
Choose ON to have the system accept all calls.
Choose OFF to have the system respond to "blocked"
calls with the pre-recorded announcement, "We're
sorry, blocked calls to this number cannot be
accepted, " and hang up without recording a message.
Accept Blocked Calls is preset to ON.
3
Hide quick links:
Advertisement
Table of Contents
