Adjusting Wire Feed Starting Speed - Miller Electric XR Control Owner's Manual

5-14. Adjusting Wire Feed Starting Speed

Tools Needed:
Nonconductive
1/4 in
OM-1594 Page 24
1
Top Of PC1
To adjust wire feed starting speed,
proceed as follows:
1 Motor Speed Control Board
PC1
2 Motor Start Control
Potentiometer R3
Remove protective white rubber
cap before making adjustment.
Adjust potentiometer using a small
nonconductive screwdriver. Turn
potentiometer clockwise
increase time it takes the motor to
ramp up to speed.
Reinstall side panel.
2
Ref. 801 557-B / 197 716
to