Meter Circuit Board Settings - Miller Electric XR Control Owner's Manual

5-8. Meter Circuit Board Settings

1 2
X Means switch position does not affect
specified function.
.
Means switch must be in this position.
1 2 3 4
Switch settings from the factory.
.
For sense lead, connect PLG51 to PLG50.
Before feeder can be used with a power
source that does not support pins F and H, a
voltage sensing lead must be installed in feed-
er. Volt sensing lead kit 209867. See section
5-7 for information regarding installation of
voltage sensing lead.
For voltage feedback, connect PLG51 to
PLG52.
Arc Voltage Sensing Using Voltage Sensing
Lead For Welding Power Source That Does
Arc Voltage Sensing Using Feedback From
Welding Power Source That Does Support
Tools Needed:
1/4 in
5
Voltage Sensing Function
Not Support Pins F And H
1 2 3 4 5
Or
Pins F And H
1 2 3 4 5
1 Meter Board PC2
2 DIP Switch S2
Set DIP switch S2 for type of
welding power source, and desired
wire feed speed display.
Reinstall hinged door and side
panel.
1
2
Digital Meter Display
Meters/Minute
1 2 3 4 5
Or
Inches/Minute
1 2 3 4 5
Ref. 802 359 / Ref. 186 266
OM-1594 Page 19