Section 6 − Maintenance & Troubleshooting; Routine Maintenance; Blowing Out Inside Of Unit - Miller Electric XMT 304 CC/CV Owner's Manual

SECTION 6 − MAINTENANCE & TROUBLESHOOTING

6-1. Routine Maintenance

6-2. Blowing Out Inside Of Unit

OM-233 045 Page 26
Replace
Damaged Or
Unreadable
Labels
!
Disconnect power
before maintaining.
3 Months
Repair Or
Replace
Cracked
Cables
6 Months
Blow Out Inside
.
Maintain more often
during severe conditions.
Replace Cracked
Torch Body
Repair Or Replace
Cracked Cables
And Cords
Clean
And
Tighten Weld
Connections
!
Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers as
shown.
ST-801 192