Assembly And Adjustments - DeWalt DWD024S-XE Instruction Manual

– Risk of personal injury due to flying particles.
– Risk of personal injury due to prolonged use.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
Motor
Your D WALT tool is powered by a D WALT-built motor. Be sure your power supply
E E
agrees with the nameplate markings. Voltage decrease of more than 10% will cause
loss of power and overheating. All D WALT tools are factory tested.
E
FIG. 1
I
D
C
H
A
B
G
COMPONENTS (Fig. 1)
WARNING: Never modify the power tool or any part of it. Damage or personal
injury could result.
A. Variable speed trigger switch
B. Lock-on button
C
SHOWN IN
FORWARD
POSITION
A
J
F
E
G. Side handle
H. Depth adjustment rod
C. Forward/reverse lever
D. Chuck
E. Cord protector with key holder
F. Cord set
INTENDED USE
These heavy-duty variable speed percssion drills are designed for professional drilling.
DO NOT use under wet conditions or in presence of flammable liquids or gases.
These heavy-duty percussion drills are professional power tools.
DO NOT let children come into contact with the tool. Supervision is required when
inexperienced operators use this tool.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of injury, turn unit off and disconnect tool from
power source before installing and removing accessories, before adjusting or
changing set-ups or when making repairs. Be sure the trigger switch is in the OFF
position. An accidental start-up can cause injury.
Side Handle (fig. 1)
WARNING: To reduce the risk of personal injury, ALWAYS operate the tool with the
side handle properly installed. Failure to do so may result in the side handle slipping
during tool operation and subsequent loss of control. Hold tool with both hands to
maximize control.
A side handle comes assembled with the DWD024S-XE. The side handle (G) can be
adjusted to suit both right-hand and left-hand users.
TO ADJUST THE SIDE HANDLE
1. Loosen the side handle (G) by turning it counterclockwise.
2. Rotate the side handle to the desired position.
3. Tighten the side handle by turning it clockwise.
TO CHANGE SIDES
For right-hand users: slide the side handle clamp over the chuck, handle at the left.
For left-hand users: slide the side handle clamp over the chuck, handle at the right.
4
I. Mode selector
J. Main handle