Dimplex CX-WIFI 6700530100 Owner's Manual page 8

Installation
most appropriate to your
installation, and replace the
compartment cover.
! NOTE: There is a plastic tab
which is associated to a back up
battery to assist with the syn-
chronization of the heaters. It is
recommended that the tab remain
in place until the time of synchro-
nization. (Figure 3)
6. Adjust the support stand to
have the stand open and se-
cure. (Figure 2)
7. Reattach the support stand to
the unit.
8. Plug the unit into the wall
receptacle and place unit in
desired location.
Wall Mount Installation
1. Determine an appropriate lo-
cation to mount the Multi-zone
Wi-Fi controller, in the vicinity
of a 120V wall receptacle and
a Wi-Fi router with an active
internet connect.
2. Remove the Multi-zone Wi-Fi
Controller and installation
hardware from its package.
3. Remove the support stand and
compartment cover from the
unit. (Figure 1 & 2)
4. Install the power cord to the
8
Figure 3
Battery Tab
Figure 4
Screw
unit in the provided USB con-
nection, located under the
compartment cover.
5. Route the wire in the track
most appropriate to your
installation, and replace the
compartment cover.
! NOTE: There is a plastic tab
Mounting
Holes
Wall Anchor
Wall Mounting
Bracket
www.dimplex.com