Table of Contents
Advertisement
CLEANING THE UNIT
To prevent fire or shock hazard, disconnect your unit from the AC power source
when cleaning.
If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax
or polish sprays on the cabinet.
If the front panel becomes dirty or smudged with fingerprints it may be cleaned
with a soft cloth slightly dampened with a mild soap and water solution. Never use
abrasive cloths or polishes as these will damage the finish of your unit.
CAUTION: Never allow any water or other liquids to get inside the unit while cleaning.
Symptom
No Charging
No Sound
Cell phone will
not charge
TROUBLESHOOTING GUIDE
Possible Problem
AC Adaptor is not plugged
into a wall outlet or the
connector is not plugged
into the power supply jack
on the back of the unit.
Wall outlet is not
functioning.
Main power switch on the
back of the unit set to OFF
position.
Bluetooth speaker is not
linked with the cell phone.
Speaker placement out of
range.
Volume set too low.
The unit is in battery
operated mode.
Cell phone is not
installed properly.
Cell phone is locked up or
frozen.
Cell phone battery has
problem.
Plug the AC adaptor into a wall outlet
and plug the connector into the
supply jack on the unit.
Plug another device into the same
outlet to confirm the outlet is working.
Set the main power switch to ON
position.
Go through "Bluetooth Operation"
process to link the speakers.
Relocate the speaker within
Bluetooth operating range.
Press the Volume+ button to turn the
sound level up.
Connect the AC adaptor to the unit
and set main power switch to the ON
position.
Remove your cell phone from the
charging
obstruction on the connectors.
Please make sure your cell phone is
working properly before plugging
into the unit. Please refer to your
cell phone manual for details.
E-11
Solution
cord
and
check
for
Advertisement
Table of Contents
