Network Settings; Manual Network Settings - Philips 55PFL6900 User Manual

Network settings

1
Press Q and use J K to Select Setup, then press OK.
2
Use H I J K to Select Network settings, then press OK.
3
Adjust the following items.

Manual network settings

1
Use H I to Select Manual network settings, then press OK.
Manual network settings Network selection
Connection test Wireless network setting
IP configuration
Setting status
Home network Proxy configuration
Wake-on-LAN(DIAL)
Net TV
Reset network settings
Network selection
2
Use H I to Select Network selection, then press OK.
3
Use H I to Select the desired setting, then press OK.
If you connect to an Ethernet Cable, select Wired
Wired
to connect to the Internet.
If you have a router with WPS function, select
Wireless
Wireless to connect to the Internet.
Wireless network setting
This menu is displayed only when you set Wireless in Network selection.
In order to use a wireless network, you must set up a connection to the
AP (e.g. Wireless Router).
2
Use H I to Select Wireless network setting, then press OK.
Auto
Search for wireless networks automatically and select the SSID from the
list.
3
Use H I to Select Auto, then press OK.
4
The list of wireless networks will be displayed. Use H I to Select the
appropriate the SSID, then press OK.
Auto Router 1
Manually enter your SSID Router 2
Router 3
Router 4
•
If you select the SSID with
will appear. Enter the WEP
wireless network using H I J K, then press OK.
•
If you select the SSID has a WPS, the WPS setting screen will appear.
Use H I J K to Select a setting, then press OK.
Easy Connect
WPS code
Manual
, WEP / WPA / WPA2 Key entry screen
*2
/ WPA / WPA2 key of the selected
*2
Select this Setting if your Router has a Wi-Fi
Protected Setup (WPS) button. Start Scanning for
wireless networks on the TV after pressing the WPS
Easy Connect
button on your Router. If Connection Ttest fails, try
Easy Connect again.
Router's Manual for more details.
Select this Setting if your Router has a WPS but
does not have a WPS button. Enter the 8-digit
WPS code
WPS PIN code shown on your TV in the Router
settings menu via PC before Connect is selected.
If your wireless network with authentication setting
(WEP , WPA or WPA2), WEP
*2
entry screen will appear. Enter the WEP
Manual
WPA2 key of the selected wireless network using
H I J K, then press OK.
*1 WPS (Easy Connect) cannot be used when the security protocol is
set to WEP. Change the Access Point's security mode from WEP to
WPA or WPA2 (recommended).
*2 WEP is not recommended to be used due to its Major security flaws.
Change the Security protocol on the Wireless Router to WPA or
WPA2 (recommended) mode.
Confirmation message will appear. Select OK to complete the settings.
Note(s)
•
For a wireless network with authentication setting, key icon appears to the right hand of the
SSID.
•
Signal icon shows the strength of the signal.
•
WEP / WPA key appears as asterisks on the confirmation screen.
*2
•
The wireless LAN supports following specifications.
–Wireless standards: IEEE 802.1 1 a/b/g/n/ac
–Frequency spectrum: 2.5GHz / 5GHz
–Security protocol: WEP / WPA / WPA2
*2
39
.
English
If it fails then refer to the
*1
/ WPA / WPA2 Key
*2
/ WPA /
*2
Continued on next page.