Table of Contents
Advertisement
USING YOUR INTELLIGENT HANDSET
Read this section to learn how to get up and running with your new satellite phone.
Power-On Messages
The system phone is powered on and off by the panel power switch. In addition, the
system can be put into power down mode by using the power button on the bottom of
the handset.
When you turn your phone's power on, it performs a self test to let you know it is
operational. You may see a number of other power-on messages (see below).
When the 0 (no service) indicator disappears and the (home system) indicator
appears, you are ready to start calling.
Once your phone is powered on, you may see:
Message
Searching.
Registering
Enter Phone Unlock Code
Enter PIN
Insert Card
Check Card
Blocked
Bad Card See supplier
RST625 INSTALLATION & USER MANUAL
The phone is attempting to establish communications
with the satellite network.
See "Accessing the Network" for more information.
Your phone is registering with the network. When the
process is complete, you will see Registered. See
"Accessing the Network" for more information.
Your phone was locked after the last use. Enter your
four-digit unlock code and press to proceed. See
"Locking and Unlocking Your Phone" for more
information.
Enter the four-to eight-digit SIM card PIN code
provided by your service provider and press to
proceed. See "Protecting the SIM Card" for more
information.
Power off your phone; make sure your SIM card is
inserted completely; and then power your phone on
again.
This message indicates that the SIM card is damaged
or inserted the wrong way.
If the SIM card PIN code is incorrectly entered three
times in a row, your phone becomes blocked. See
"Unblock the PIN Code" for instructions on how to
to unblock it.
Your SIM card has been damaged or incorrectly
issued. Contact your service provider for information.
REV 03
Description
17
Advertisement
Table of Contents
