General - Hyundai H-1 Repair Manual

GENERAL

1. Basically, all measurements in this manual are taken with a
tacking gauge.
2. When a measuring tape is used, check to be sure there is no
elongation, twisting or bending.
3. For measuring dimensions, both projected dimension and ac-
tual-measurement dimension are used in this manual.
MEASUREMENT METHOD
PROJECTED DIMENSIONS
1. These are the dimensions measured when the measurement
points are projected into the reference plane, and are the
reference dimensions used for body alterations.
2. If the length of the tacking gauge probes are adjustable, make
the measurement by lengthening one probe by the amount
equivalent to the difference in height of the two surfaces.
ACTUAL-MEASUREMENT DIMENSIONS
1. These dimensions indicate the actual linear distance between
measurement points, and are the reference dimensions for use
if a tacking gauge is used for measurement.
2. Measure by first adjusting both probes to the same length
(A=A').
NOTE
Check the probes and gauge itself to make sure there is no
free play.
MEASUREMENT POINT
1. Measurements should be taken at the hole center.
GENERAL
45
Height
Projected dimension
DIM0010
A
A'
DIM0020
Hole center
DIM0030