Gaggia Anima Service Manual page 33

GAGGIA ANIMA
Page 5: High voltage loads test (Heater , Grinder ):
a) Heater (230V AC)
b) Grinder (320V DC)
The user can change the page by pressing the Z7 button.
Page 0 is accessible only entering Test Mode from power-off mode; at the start up all loads are
turned off.
Page 0 (FIRMWARE) Page 0 (FIRMWARE)
ERROR: If in machine model fi eld is written "Unknow" and backlight of display is Red, check the ERROR: If in machine model fi eld is written "Unknow" and backlight of display is Red, check the
jumper in interface. jumper in interface.
TEST MODE Level0
Pressing button Z7
TEST MODE Level1
Pressing button Z7
TEST MODE Level2
Pressing button Z7
TEST MODE Level3
Pressing button Z7
TEST MODE Level4
Pressing button Z7
TEST MODE Level5
Verify the fi rmware version Verify the fi rmware version
Firmware version on the display. Firmware version on the display.
The machine model is shown (Focus ⇒CMF, Class ⇒AMF, Top ⇒OTC). .
The machine model is shown
The voltage of the main supply "230V" The voltage of the main supply "230V"
The frequency of the main supply is shown (50 or 60 Hz) The frequency of the main supply is shown (50 or 60 Hz)
The fi rmware version is the same as the label on MicroController The fi rmware version is the same as the label on MicroController
ERROR: The fi rmware version is different from the label on MicroController;
change the CPU_POWER Boards !
Press Press Z7 Z7 " "
The machine passes to the Page 1 (KEYBOARD) The machine passes to the Page 1 (KEYBOARD)
ERROR: The page does not change; Check the interface board and
the fl at cable (JP21)
" to move to the next screen " to move to the next screen
05 TROUBLESHOOTING
Pressing button Z7
Pag. 2/9